The correct replacement winch for the SnowBear Personal Snowplow for 2" Hitches - 82" Wide x 19" Tall part # SB324-080 is the Replacement Single Speed Electric Winch part # SB263-282. There is not individual replacement parts for the winch unfortunately. view full answer...
My contact at Fulton tells me that they don't offer a replacement strap for the discontinued Fulton 500621 electric winch, but I found that the winch uses a 2 inch wide strap and fastens to the winch spool using a bolt that passes through a loop that has been sewn into the end of the strap. The 4000 lb capacity 15' x 2" Dutton-Lainson # DL24239 replacement strap would install in the same manner, so it'll work just fine for your Fulton 500621 electric winch. This is the longest strap that's... view full answer...
It sounds like there is a solenoid that is bad on your power winch. As we do not carry those or have parts for them I recommend replacing the winch with a Dutton-Lainson StrongArm Electric Winch # DL25215. The winch comes with a 2" wide by 20' long strap.
The Dutton-Lainson Mounting Adapter Plate # DL24055 will make it easier to mount the new winch. view full answer...
The highest rated hand winch we have for a boat trailer is the Fulton High-Performance 2-Speed Trailer Winch with Handbrake # F142430 which is rated for 3,700 lbs.
If you're needing something more than that then we need to look into electric winches. The best one for this application is the Dutton-Lainson StrongArm Electric Winch # DL25215 which is rated for 9,000 lbs.
Attached are some review videos for you to check out. view full answer...
Either of these two options would work. You will need an electric winch that loads in an out, so you can raise and lower your pop up. The Superwinch LT2000 ATV Winch - Wire Rope - Roller Fairlead - 2,000 lbs, part # 1120210, you attached to your question is a perfect option.
If you plan on using a manual winch instead, you can use the Dutton-Lainson Hand Winch - TUFFPLATE Finish - 2 Speed - Direct Drive - 2,500 lbs, part # DL14830, which can raise and lower your pop up. If you need replacement... view full answer...
For your boat trailer I recommend the Dutton-Lainson StrongArm Electric Winch w/ Remote # DL25010. This winch comes with a remote and has a load capacity of 3,000 lbs. Assuming you have roller bunks you will have a 3:1 ratio, which will be enough to handle your Grady White Gulfstream. view full answer...
Yes, we do have the 3-way In/Off/Out switch for your Strong Arm winch.
- Replacement In/Off/Out 3-Way Switch for Dutton-Lainson StrongArm Electric Winches # DL42QR
This is the correct replacement 3-way In/Off/Out switch for the Dutton-Lainson Remote Hand-Held Switch for AC StrongArm Electric Winches # DL24052. view full answer...
I spoke to Dutton-Lainson and there is replacement wiring for the StrongArm Electric Trailer Winch - Marine - 1,500 lbs # TW4015. The Wiring Harness for DC StrongArm Electric Winches # DL24151 will be a direct replacement, or addition in your case. view full answer...
I am glad to hear you have enjoyed your Dutton-Lainson StrongArm winch. It is a quality product. The circuit breaker you are looking for is part # # DL304025. This is the 80 Amp replacement fuse for the Dutton-Lainson StrongArm Winch Wiring Harness.
I have attached a link to this part for you. view full answer...
I reached out to my contact at Reese and they were able to confirm that a replacement handheld remote isn't available for your Reese Towpower 2,000 lb electric winch, model 7033600.
Economy winches like these aren't designed to be serviceable, so replacement parts aren't offered. This means that you will only be able to use the standard hand crank to operate it going forward.
The Bulldog Winch Trailer Winch # BDW15017 would be a nice upgrade to your 2K Towpower winch. It features a 1.5-horsepower... view full answer...
The correct replacement strap for the Dutton-Lainson StrongArm Electric Winch TW9000 part # DL25215 which has a 3,000 lb weight capacity is the Hand Winch Strap with Safety Hook part # DL24251. view full answer...
It sounds like the thrust bearings may be bad on your Dutton-Lainson TW400 StrongArm Electric Winch, part # DL25200.
I have attached the installation instructions and in the instructions there is an exploded view of the winch and its components. My contact at Dutton-Lainson told me that they are 99 percent sure the thrust bearings are bad. We do have a replacement kit that includes the bearings, the washers and a retaining clip. That kit is part # DL6381.
This kit should take care of... view full answer...
I have the part you need! I went ahead and reached out to my contact at Dutton-Lainson, and they confirmed that the replacement rectifier you need is the Replacement Bridge Assembly for AC Powered Dutton-Lainson StrongArm Electric Winch - Qty 1 # DL92QR. This bridge assembly fits winch models SA5000AC, SA5000AC-CSA, SA5015AC, SA50151AC-CSA, SA7000AC, SA7000AC-CSA, SA7017AC, and SA7015AC-CSA.
This part is a direct replacement of CP2506. view full answer...
The Dutton-Lainson Hand Winch part # DL14934 is a suitable choice with a 1,200lb capacity to replace the Shelby Winch 5438 on your pop-up camper. It is also made in the U.S.A. and comes with a five year warranty. You can reuse your existing cable/strap or replace it with either part # DL24045 or part # DL24249.
I have attached review videos on the above winch and replacement parts for you. view full answer...
We have the Replacement Single Speed Electric Winch w/ In-Cab Switch for SnowBear Personal and UTV Snowplows part # SB263-282. Unfortunately we do not have the motor by itself as a stand alone. view full answer...
The Dutton-Lainson StrongArm Electric Winch # DL25727 is likely going to be your best solution. This winch is rated for 1,200lbs and includes a 10' cord to plug into a 120-volt outlet. It has as 10' wired remote allowing you to run the line in or out and switch the motor on and off. A dynamic brake will hold the line as moving in and out and a mechanical brake will lock the real when the motor is switched off. view full answer...
For your application I recommend the Replacement Single Speed Electric Winch w/ In-Cab Switch for SnowBear Personal and UTV Snowplows # SB263-282. This is the same winch and wiring that you currently have so it will plug right in and then you can hang on to the extra wiring in case you need it down the road.
The winch isn't available as it's own part which is why it's offered in a kit like this. view full answer...
The Dutton-Lainson Hand Winch # DL14964 is going to be the standard brake type winch to replace your B1500. This has the same 1,500lb capacity. I do not recommend changing to a chain drive as those can frequently have issues with the chain and gears. view full answer...
The Replacement Brake Disc Assembly part # DL304422 is not included with the Replacement Brake Spring Kit part # DL5703160. These are separate parts for the Dutton-Lainson StrongArm Electric Winch (SA12015DC) part # DL25040. view full answer...